How To Remove A Seized Oil Filter Canister On A 2008 Toyota Sequoia

Introduction

Changing the oil and oil filter of a Toyota Tundra a simple only a necessary task. It should be done every 3 months or every 3000 miles, which ever comes kickoff. Following these steps will show you how to properly alter your trucks oil. The same process can be followed for 2007-2013 Toyota Tundra's.

Before getting started, note that a jack was not used in this oil change. A jack should never be used to do a oil change because of the safety risk associated with it.

Begin by locating the skid plate. The Skid plate is attached by 5 Hex screws and 3 plastic retainer nuts. First, remove the 3 plastic retainer nuts by pulling on them until they are released.

Begin past locating the skid plate. The Sideslip plate is attached by 5 Hex screws and 3 plastic retainer nuts. Start, remove the 3 plastic retainer basics past pulling on them until they are released.

Next, obtain a socket wrench and ¼ extended socket. Start removing the 5 Hex screws. Remove the screws in a star pattern. Caution before removing the last 2 Hex Screws, have someone or something holding the skid plate so it does not fall.

Next, obtain a socket wrench and ¼ extended socket. Kickoff removing the 5 Hex screws. Remove the screws in a star pattern. Caution before removing the last 2 Hex Screws, take someone or something holding the slip plate so it does not fall.

Open oil fill up cap and pull out dipstick slightly to let for an open system when draining. These are located under the hood

Locating the drain plug on the oil pan. Place bleed pan underneath the drain plug in order to catch the one-time oil.
Using a ratchet and xiv mm socket, plough the bleed plug counter-clockwise until drain plug comes out and oil starts to drain. Circumspection, oil may exist warm if car had been operated within 30 minutes

Remove any gasket material from the drain plug and supercede the sealing gasket. Screw the oil drain plug back into oil pan . Tighten until snug, do not over tighten

Locate the oil filter and brainstorm to remove the oil filter cap. To exercise and then, outset grasp the oil filter canister with an oil filter wrench.
And then insert a ⅜ socket and slowly turn counterclockwise to loosen but the oil filter cap. This will expose the oil filter drain featherbed.

Place bleed pan underneath oil filter and firmly Insert oil filter cap drain tool. This comes with the filter when you buy it. Oil volition begin to drain from inside the filter canister.
When draining has stopped, remove drain tool by firmly pulling down.

To remove oil filter canister, utilize an oil filter wrench. Unscrew by turning counter-clockwise.
Remove the old oil filter from oil filter canister and replace with the new i.

Re-install oil filter canister. Tighten oil filter canister to 20-30nm
Supercede oil filter gasket to insure the oil filter will not leak. This comes with the new oil filter
Reinstall oil filter cap. Tighten until snug, practice non over tighten

Using a funnel, pour in the new oil into the engine. Consult owners manual to run across proper oil to utilize equally well every bit amount of oil to add
Reinstall oil fill cap once filling oil is complete

Pull the dipstick out in smooth upward motion, wiping off the dipstick, reinstall, and pull the dipstick out once more than to check level. Oil should be between dots on the bottom of dipstick
Write down date of oil change and amount of miles on vehicle to indicate when you should change your oil again.

Conclusion

Changing your cars oil is the near of import maintenance process that should be washed for your vehicle. It tin easily exist done at home rather than taking it to an good and existence charged extreme amounts.

Embed this guide

Cull a size and re-create the code beneath to embed this guide as a small widget on your site / forum.

Preview